Untangle Saw Trick 101: How to Untangle a Chainsaw Chain

picture from:https://sumogardener.com/ 

Can’t get loops out of a saw chain?

Don’t worry; you are not alone. All the guys out there who are an owner of a chainsaw can realize it. The good news is you come to the right place. Today, I am going to show you the easiest way to untangle the chain. So that after the end of this how to untangle a chainsaw chain, you have a clear on the basic of untangling saw. Stay along.

Preparation before Starting

Untangling the chain can be very boring if you don’t know the appropriate process. Things you need to prepare to continue the process are

• A Sturdy Table or surface
• Chainsaw Gloves
• Tools
• Lubricating Oil
• Protective Goggles

Untangling the Saw Chain

As we mentioned earlier, keeping yourself safe first. So wear the protective gloves and goggles before the start. Now follow the instruction step by step.

Step 1: Make the Necessary Preparations

Place the saw on a flat table or the workbench. If the chain has been removed from its bar, you have to use the right tools so you can remove the housing, the chain, and the bar.

But if your chain is new, find out its sharp edge to ensure that it won’t cut you. Be careful about the old one who can stick or rusted together, then loosen it with enough lubricating oil. And try to avoid scattering the oil on the floor to avoid accidents.

Step 2: Figure out the Two opposite Loops

After taking a good preparation, now you have to find out the two opposite loops in the chain. Place each of the hands on the loop to allow it to hang down using these two points. Meanwhile, it will help to unravel the chain by lessening the complexity of the tangle.

Step 3: Making both Loops Bigger

In this stage, you can assume the full extent of the tangle. Now try to find out the possible way to make those loops bigger till it is good enough to make it in one single loop. Ensure that your hands are in the two most opposite loops. You can use a slack on the chain.

Step 4: Untangling the Chain

                                                   picture from: https://sumogardener.com/ 

Your hands are still in that place, right? Great, then located at the lowest part of the saw’s chain. Now guide and allow shooting straight up. Remember that chains are quite stiff. To apply the correct techniques to raise the loops easily.

Also, it will allow the gravity to let that raised portion smoothly. Meanwhile, if there is any tangle still, you must make two loops to repeat the same process.

Step 5: Spreading Them Apart

If three steps of above did not work very well at all for you, then this part is for you. Try to untangle by focusing on each tangle or loop. Also, spread each of them as possible. This is to make it less complicated. chainsaw sharpener is another important topic for chainsaw lover.

Tip

·         New chains are quite clean and well-oiled. But when you are working with an old chain, clean off all the debris. Also, spray a bit of lubricating oil to help it slide more easily to untangle.